VTech CareLine SN1157 - Remote Access Code; Message Alert Tone

50
Answering system settings
Remote access code
A two-digit security code is required to access the answering system
remotely from any touch-tone telephone. The preset code is 19. You
can set the code from 00 to 99.
To set remote access code with a cordless handset:
Press MENU when idle.
Scroll to Answering sys, then press SELECT.
Scroll to Ans sys setup, then press SELECT.
Scroll to Remote code, then press SELECT.
Enter a two-digit number, then press SELECT.
To set remote access code with the telephone base:
Press MENU when idle, then press SELECT to select Answering system.
Scroll to Ans sys setup, then press SELECT.
Scroll to Remote code, then press SELECT.
Enter a two-digit number, then press SAVE.
Message alert tone
When the message alert tone is set to On, and there is at least one new
message, the telephone base beeps every 10 seconds. The message
alert tone is preset to Off.
There is no audible alert at the handset.
To set message alert tone with a cordless handset:
Press MENU when idle.
Scroll to Answering sys, then press SELECT.
Scroll to Ans sys setup, then press SELECT.
Scroll to Msg alert tone, then press SELECT.
Scroll to On or Off, then press SELECT.
1.
2.
3.
4.
5.
1.
2.
3.
4.
1.
2.
3.
4.
5.