EN - 23
English
Question Suggestions
I hear noise on the cordless handset and the
keys do not work.
• Make sure the Cat-5 network cable is
plugged in correctly and securely.
• Unplug the Cat-5 network cable. Wait
for 15 seconds before plugging it back
in.
Common cure for electronic equipment.
• If the telephone is not responding
normally, put the cordless handset in the
handset charger. If it does not fix the
problem, try the following (in the order
listed):
1. Disconnect the power to the base station.
2. Disconnect the battery on the cordless
handset.
3. Wait a few minutes before connecting
power to the base station.
4. Install the battery again and then place
the cordless handset in the handset
charger.
5. Wait for the cordless handset to
synchronise with the base station. Allow up
to one minute for this to take place.
To Next Page
Loading...
