EN - 22
Question Suggestions
The cordless handset beeps and is not
performing normally.
• Make sure the Cat-5 network cable is
plugged into the LAN port of the base
station and the network wall jack with
Power over Ethernet (PoE).
• Check your SIP server or telephone
administrative settings. Refer to the SIP
Phone Configuration Guide for details.
• Disconnect the base station from
the network wall jack and connect
a different working SIP telephone. If
the other SIP telephone has the same
problem, the problem is in the wiring or
network server. Contact your telephone
service provider (charges may apply).
• Other electronic products such as HAM
radios and other DECT phones can
cause interference with your cordless
phone. Try installing your phone as far
away as possible from these types of
electronic devices.
There is interference during a telephone
conversation, or the call fades in and out
when I am using the cordless handset.
• The cordless handset may be out of
range. Move the handset closer to the
base station or adjust the setting of RF
transmission power. Refer SIP Phone
Configuration Guide for details.
• Other electronic products such as HAM
radios and other DECT phones can
cause interference with your cordless
phone. Try installing your phone as far
away as possible from these types of
electronic devices.
• If other SIP telephones in your hotel are
having the same problem, the problem
is in the wiring or network server.
Contact your telephone service provider
(charges may apply).
I hear other calls when using the telephone.
• Disconnect the base station from
the network wall jack and connect a
different working SIP telephone. Check
your SIP server settings. If calls are still
not clear, the problem is probably in the
wiring or network server. Contact your
telephone service provider (charges
may apply).
To Next Page
Loading...
