4
Getting started
Battery installation
Install the battery as shown below.
Battery indicators Battery status Action
The screen is blank. Battery has no charge and the
handset cannot be used.
Charge without interruption (at
least 30 minutes).
The screen shows
Place handset in
charger and flashes.
Battery has very little charge
and the handset cannot be
used.
Charge without interruption (at
least 30 minutes).
The screen shows Low
battery and flashes.
Battery has enough charge to
be used for a short time.
Charge without interruption (at
least 30 minutes).
The screen shows
HANDSET.
Battery is charged. To keep the battery charged,
place it in the telephone base
when not in use.
1 2
3
Plug the battery connector
securely into the socket inside the
battery compartment, matching
the color-coded label.
Place the battery with the label
THIS SIDE UP and the wires
inside the battery compartment.
Slide the battery compartment
cover towards the center of the
handset until it clicks into place.
Charge the handset by placing it
in the telephone base.
4
CHARGE light remains
on when charging.
Battery charging
Once you have installed the battery, the screen indicates the battery status
(see the table below).
For best performance, keep the handset in the telephone base or charger when
not in use.
The battery is fully charged after 16 hours of continuous charging.
If the handset will not be used for a long time, disconnect and remove the
battery to prevent any possible leakage.
•
•
•
To Next Page
Loading...
Need help?
General
