VTech DS6621 User Manual

Getting started
2
Even if you do not subscribe to any conventional telephone service, you can still use the cell
line alone without plugging in a telephone line cord.
Telephone base and charger installation
Install the telephone base and handset charger(s) as shown below.
Make sure that the electrical outlet is not controlled by a wall switch.
If you subscribe to digital subscriber line (DSL) high-speed Internet service through
your telephone line, you must install a DSL filter between the telephone line cord
and the telephone wall jack. The filter prevents noise and caller ID problems caused
by DSL interference. Contact your DSL service provider for more information about
DSL filters.
Telephone base
Charger
Charger
adapter
Telephone
base power
adapter
A DSL filter (not
included) is required
if you have DSL
high-speed Internet
service. The DSL
filter must be plugged
into the telephone
wall jack.
Electrical
outlet not
controlled by
a wall switch
Telephone wall jack
Electrical outlet
not controlled by
a wall switch
Telephone line cord
CAUTION:
If you subscribe to telephone service from a cable company or a VoIP service
provider, contact your cable/VoIP service provider for more information.

VTech DS6621 Specifications

Frequencies and Channels

DECT frequency	1921.536-1928.448 MHz
Bluetooth frequency	2402.000-2480.000 MHz
DECT channels	5
Bluetooth channels	79

Power Requirements

handset battery voltage	2.4 V
charger voltage	6 V
charger current	300 mA

Memory

phonebook memory locations	1000
phonebook digits capacity	30 digits
phonebook characters capacity	15 characters
caller ID log memory locations	50
caller ID log digits capacity	24 digits
caller ID log characters capacity	15 characters