Settings
15
Ringer tone
You can choose from different ringer tones on the base unit.
Press when the base unit is not in use.
Press or until the base unit displays Ringers, and then press .
Press to highlight Ringer tone, and then press .
The base unit displays RINGER TONE with the current setting. Press or to
sample each ringer tone (Tone 1 to Tone 10).
Press to save your selection. You hear a confirmation tone.
If you turn off the ringer volume, you will not hear ringer tone samples.
Set date and time
The date and time will be displayed on the base unit when idle. Before using the
ErisStation Conference Phone, set the date and time as follows. If you subscribe to
caller ID service, the day, month, and time are set automatically with each incoming
call. However, the year must be correct so that the day of the week can be calculated
from the call log information.
Press when the base unit is not in use.
Press or until the base unit displays Set date/time, and then press .
Press or to select the month, and then press , or use the dialing keys to
enter a two-digit number (01-12).
Press or to select the date, and then press , or use the dialing keys to
enter a two-digit number (01-31).
Press or to select the year, and then press , or use the dialing keys to
enter a two-digit number (00-99), and then press .
Press or to select the hour, and then press
, or use the dialing keys to
enter a two-digit number (01-12).
Press or to select the minute, and then press
, or use the dialing keys to
enter a two-digit number (00-59).
Press or to select AM or PM.
Press
to save the settings. You hear a confirmation tone.
The base unit beeps twice if you enter an invalid number.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
6.
7.
8.
9.
To Next Page
Loading...
Need help?
General
