EasyManuals Logo
Home>VTech>Conference Phone>ErisStation VCS704

VTech ErisStation VCS704 User Manual

VTech ErisStation VCS704
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
27
Wireless microphone unit registration
Your wireless microphone units are pre-registered. If for some reason, you want to
purchase replacement wireless microphone units (VCS704-WM), visit our website at
http://businessphones.vtech.com or call 1-800-595-9511. In Canada, call
1-800-267-7377. You should register your new wireless microphone units to the base
unit following the instructions below.
To register a wireless microphone unit
As part of this process, all existing, broken, or lost wireless microphone units will be
deregistered first. Then, the base unit will re-register the four wireless microphone
units that are placed into the charging cradles.
Before registration, unplug the telephone line cord from the wall jack to make sure
there are no incoming calls during registration.
Gather the four wireless microphone units that are to be registered and place them
into the charging cradles.
Enter 331734 on the base unit when it is not in use, and then press .
The screen displays Please place all wireless mics on cradle, then
press ‘SELECT’.
Make sure all the four wireless microphone units are on the charging cradles, and
then press . The wireless microphone units enter the deregistration mode,
and the screen displays Processing...
When deregistration is complete, registration starts. The screen displays
Registering... 1 2 3 4. The number X blinks while registering the X-th wireless
microphone unit. You hear a confirmation tone when each wireless microphone unit
is registered. When all the four wireless microphone unit are registered, the base unit
displays Registration done.
After registration, plug the telephone line cord back into the wall jack.
If registration has failed, the base unit will display Registration failed. Try again and returns to
idle. You hear an error tone. Remove the microphone units from the charging cradles and place
them back in. Repeat steps 1 to 3 to try the entire registration process again.
If the screen does not display Registration done after step 3, repeat steps 1 to 3 to try the entire
registration process again.
All wireless microphone units should always be kept on the charging cradles during
deregistration and registration. Any wireless microphone unit which is registered before but not
put into the charging cradle will be deregistered after the above operations.
Status indicators on the wireless microphone units flash red and green alternately during
registration.
To cancel registration, press . The base unit displays Registration cancelled. If registration
is cancelled, some of the wireless microphone units may be deregistered. To register them back
to the base unit, repeat steps 1 to 3 to try the entire registration process again.
1.
2.
3.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the VTech ErisStation VCS704 and is the answer not in the manual?

VTech ErisStation VCS704 Specifications

General IconGeneral
BrandVTech
ModelErisStation VCS704
CategoryConference Phone
LanguageEnglish

Related product manuals