Getting started
10
Locating the doorbell
Before mounting the doorbell on a wall, make sure you test if the location you install
the doorbell is in range, and adjust the camera angle to best suit your needs.
To test the location for installation:
Hold the doorbell in the location where you want to install the doorbell, then follow the
steps below to test the reception range and video capture angle.
Press MENU >> Press q or p to Settings >> Press SELECT.
Press q or p to Doorbell setup >> Press SELECT.
Press /DOORBELL to check the video streaming quality. Press ISO, then press
+ or - to adjust the video streaming brightness.
If audio feedback occurs, press on the handset to turn off the speakerphone.
If the desired location is in good range, the handset displays .
If the desired location is not in good range, the handset ashes in red. Press
INFO for instructions to relocate your handset and/or telephone base. When the
reception is in good range, the handset displays . Press OK to return to the
video streaming.
Keep the video streaming on for camera lens adjustment.
When nding a desirable location for the doorbell:
Make sure the visitor is standing in a reasonable distance away from the doorbell.
Avoid mounting it on a location which is subjected to vibration or shock.
Avoid mounting it on an enclosed area where it may cause echoes.
Avoid mounting it to where it is exposed to direct sunlight.
1.
2.
3.
•
•
•
4.
•
•
•
•
To Next Page
Loading...
Need help?
General
