Appendix
88
Screen messages
Area code will
not show in
Caller ID log
The home area code you saved will not be shown in caller ID log.
Caller ID log
empty
There are no caller ID log entries.
Caller ID won’t be
announced.
The ringer volume on the handset is turned off so no caller ID
information will be announced for incoming calls.
Calling
all handsets
(for models with more than
two handsets)
The handset is calling all system handsets.
Calling HANDSET X
You are calling another handset.
Call transferred
You have successfully transferred an outside call to another
handset.
Contact deleted
A directory entry is deleted.
Directory empty
There are no directory entries.
Directory full
The directory is full. You cannot save any new entries unless you
delete some current entries.
Ended
You have just ended a call.
Handset X is
calling
Another system handset is calling (for intercom calls).
Incoming call
There is an coming call.
Intercom
The system device is on an intercom call.
Intercom ended
The intercom call has just ended.
INTERCOM TO:
You have started the intercom process, and need to enter the
number of the system device you wish to call.
Line in use
A system device or another telephone on the same line is in use.
Low battery
The handset battery needs to be recharged.
Microphone off
The microphone is off. The other party cannot hear you.
Microphone on
The mute function is turned off and the other party can hear you.
New voicemail
There are new voicemail messages from your telephone
service provider.
No answer.
Try again.
You tried to make an intercom call, but the handset you are calling
is busy or out of range.
To Next Page
Loading...
Need help?
General
