Use your smartphone or mobile device to access our online help.
Go to https://help.vtechphones.com/rm5764hd or https://help.vtechphones.com/rm5764-2hd; OR
RM5764HD online help
Scan the QR code on the right. Launch the camera app or QR code scanner app on your smartphone or tablet. Hold the device’s camera up to the QR code and
frame it. Tap the notification to trigger the redirection of the online help.
– If the QR code is not clearly displayed, adjust your camera’s focus by moving your device closer or further away until it is clear.
If you would like to contact us, visit https://help.vtechphones.com/cs.
RM5764-2HD online help
You can also call our Customer Support at
1-844-848-8324 (1-844-84-VTECH) [in US] or
1-888-211-2005 [in Canada] for help.
Mount the baby unit (optional)
NOTES
Check for reception strength and baby unit angle before drilling the holes.
The types of screws and anchors you need depend on the composition of the wall. You may need to purchase the screws and anchors separately to mount your
baby units.
1. Place the wall mount bracket on a wall and then use a pencil to mark two holes in parallel. Remove the wall mount bracket and drill two holes in the wall (7/32
inch drill bit).
2. If you drill the holes into a stud, go to step 3.
• If you drill the holes into an object other than a stud, insert the wall anchors into the holes. Tap gently on the ends with a hammer until the wall anchors are
flush with the wall.
3. Align the wall mount bracket and screws with the holes in the wall as shown. Tighten the screw in the middle hole first, so that the wall mount bracket position is
fixed. You can tighten the other screw in the top hole.
To Next Page
Loading...
Need help?
General
