Slide the switch to ON to power on your baby unit.
NOTES
When powering up, the baby unit’s status LED turns on. It will turn off after a while and keeps off.
The status LED is set to off by default. If you want to keep the LED on, press MENU, then go to
> Status LED and turn it on.
NOTE:
Camera lens and surface may get warm during normal operation.
Charge the parent unit battery before use
The parent unit runs on a rechargeable battery or AC power. To continuously monitor your baby, keep the parent unit connected to AC power. With the battery alone,
the parent unit can cordlessly run for a short time only.
NOTES
Before using the baby monitor for the first time, charge the parent unit battery for 12 hours. When the parent unit battery is fully charged, the battery icon
becomes solid .
The standby time varies depending on your actual use.
After the parent unit is fully charged, press POWER until the welcoming screen appears.
The battery icon indicates the battery status (see the following table).
Battery indicators Battery status Action
The screen displays and . The light
flashes.
The battery has very little charge and may be
used for only a short time.
Charge without interruption (about 30 minutes).
The battery icon becomes solid .
The battery is fully charged.
To keep the battery charged, connect it to AC power
when not in use.
Raise the parent unit antenna for better reception
To Next Page
Loading...
Need help?
General
