Power on or off the baby unit
Slide the ON/OFF switch to ON to turn on the baby unit. The POWER LED light turns on.
Slide the ON/OFF switch to OFF to turn off the baby unit. The POWER LED light turns off.
Power on or off the parent unit
Slide the ON/OFF switch to ON to turn on the parent unit. The screen and the POWER LED light turns on.
Slide the ON/OFF switch to OFF to turn off the parent unit. The screen and the POWER LED light turns off.
Adjust speaker volume
For parent unit: · Press VOL /VOL on the parent unit to adjust the speaker volume.
Note
· The parent unit will be muted automatically when the parent unit is talking to the baby unit. When it is muted, appears on the
screen.
For baby unit: The baby unit speaker volume determines the lullaby volume and talkback volume transmitted from parent
unit. The volume can be adjusted in the parent unit.
1. Press 2. Press 3. Press 4. Press
when the parent unit is idle. or to choose , then press or .
or to choose . or to choose the volume level of the baby unit, then press
to confirm.
Adjust LCD brightness
You can change the brightness of the parent unit screen from Level 1 to Level 5. The LCD brightness is preset to Level 3.
1. Press when the parent unit is idle. 2. Press or to choose , then press or . 3. Press or to choose the desired level of
brightness, then press
to confirm your selection.
* Monitoring mode for VM320-2 only
Every time the parent unit is turned on, it displays a baby unit in SINGLE-CAM mode. If there are more two baby units in your
system, you can also monitor your baby in PATROL mode.
SINGLE-CAM The screen displays image of a single baby unit in full screen.
PATROL A single cam view that transitions to a different baby unit every 10 seconds.
To switch from SINGLE-CAM to PATROL mode:
1. Press when the parent unit is idle. 2. Press or to choose , then press or to open the submenu. 3. Press or to select to enter
PATROL mode to alternately view the image from one baby
unit to the next one in every 10 seconds.
To switch from PATROL to SINGLE-CAM mode:
1. Press when the parent unit is idle.
2. Press or to choose , then press or to open the submenu.
3. Press or to select a camera number to enter SINGLE-CAM mode.
Note
· If one or more paired baby units are powered off or disconnected during patrolling, the parent unit will keep searching
until its power has run out or a baby unit is connected once again.
Specifications are subject to change without notice. © 2020 VTech Communications, Inc. All rights reserved. 07/20. VM320-
X_CIB_V3
3 Using the baby monitor (Con’t)
Lullaby
The baby monitor has two lullabies and two soothing sounds for you to comfort your baby. You can play the lullabies or
soothing sounds on the baby unit using the parent unit. 1. Press MENU when the parent unit is idle. 2. Press or to choose ,
then press or . 3. Press to choose , then press or . 4. Press or to choose a lullaby or a soothing sound, or choose to stop
playing. 5. Press SELECT to confirm your selection.
Notes
To Next Page
Loading...
