VTech VM320 - Zoom; Talk; Monitor the Temperature; Baby Unit Overview

When your baby unit detects a sound, which exceeds the selected sensitivity level, the sound activation triggers the parent unit
screen to turn on automatically. When no sound is detected within 50 seconds, the screen will be off again.
1. Press when the parent unit is idle.
2. Press or to choose , then press or
3. Press or to choose or , then press to open the submenu. to confirm your selection.
Note
· If the sound sensitivity is set to the highest level, the parent unit screen may remain on continuously even though sound
activation is on. This depends on whether the baby unit detects any sounds.
Zoom
You can zoom in while viewing images from the baby unit.
1. Press when the parent unit is idle.
2. Press or to choose then press or to open the submenu.
3. Press or to choose or , then press to confirm your selection.
Talk
You can use the TALK function of the parent unit to comfort your baby.
1. Press and hold TALK on the parent unit.
2. Speak towards the microphone on the parent unit. Your voice is broadcast to the baby unit.
3. Release the TALK key to stop the broadcast.
Note
· The parent unit speaker is muted during voice broadcast. Sound transmission from the baby unit resumes after TALK is
released.
Monitor the temperature
Your baby unit monitors the temperature of your baby’s room with its built-in temperature sensor. If the detected temperature
is out of the preset temperature range, the parent unit will display an alert message.
Set temperature range You can set the desired minimum and maximum room temperature alert ranges.
1. Press when the parent unit is idle.
2. Press or to choose , then press .
3. Press or to choose , then press or .
4. Press or to choose or , then press .
5. Press or to choose the desired minimum or maximum temperature, then press to confirm your selection.
Temperature alert tone You can turn on the temperature alert tone so that the parent unit will emit an alert tone if the detected
temperature is out of range.
1. Press when the parent unit is idle.
2. Press or to choose , then press .
3. Press or to choose , then press or .
4. Press or to choose or , then press to confirm your selection.
Temperature format You can choose to display the temperature in Fahrenheit (oF) or Celsius (oC).
1. Press when the parent unit is idle.
2. Press or to choose , then press .
3. Press or to choose , then press or .
4. Press or to choose or , then press to confirm your selection.
Baby unit overview
1. Pair hole
· Your baby units and parent unit provided are already paired.
2. POWER LED light · On when the baby unit is turned on and is paired to the parent unit.
· Flashes when the baby unit is not being viewed; or when the link to the parent unit is lost.