With this feature, you can choose to hear sounds from the baby unit all the time, or to hear sounds that exceed a certain
level. You can use the parent unit to adjust the microphone sensitivity of your baby unit. The higher the sensitivity level,
the more sensitive the baby unit is in detecting sounds for transmitting to the parent unit.
Sound-activated screen
When the baby unit detects no sound, the parent unit screen stays off to save power. Once a sound is detected, the
parent unit screen turns on automatically. It will then turn off again after 50 seconds of no sound detection. Temperature
You can turn on the temperature alert tone so that the parent unit beeps whenever the room temperature detected by the
baby unit falls outside of the desired temperature range. You can choose in Fahrenheit (oF) or Celsius (oC) as the
temperature format displayed, or set the maximum/minimum temperature limit for alerts.
Warning icons and messages
/No Link to Camera The selected baby unit is out of range or is turned off.
/Battery low at The battery is empty and Parent Unit needs to be recharged.
/Temperature too high or
/Temperature too low
The temperature detected by the baby unit is higher/lower than the desired temperature alert range.
The parent unit is searching for baby units. The parent unit is connected to AC power.
Dim mode
The dim mode is to help you save the parent unit power. Your parent unit display will dim automatically after 10 minutes of
inactivity, in which there is neither key pressed nor alert received from the baby unit.
Note
· While the screen is dimmed, any keypress or alert message will trigger the screen to return to the preset brightness level.
After 10 minutes of inactivity, it will dim again.
Night vision
The baby unit has infrared LEDs that allow you to see your baby clearly at night or in a dark room. When the baby unit being
viewed detects low light levels, the infrared LEDs are switched on automatically. The images from the baby unit are in black
and white, and appears on the screen.
Notes
· It is normal if you see a short white glare on your parent unit screen as the baby unit is adapting to the dark environment. ·
When the infrared LEDs are on, the images are in black and white. This is normal.
Tip
· Depending on the surroundings and other interfering factors, like lightings, objects, colors and backgrounds, the display
resolution may vary. Adjust the baby unit’s angle or place the baby unit at a higher level to prevent glare and blurry display.
Mount the baby unit (optional)
Your baby monitor comes ready for tabletop use. You can also choose to mount your baby monitor on the wall. See Mount the
baby unit (optional) in the Quick Start Guide for the wall mounting instructions.
General product care
To keep this product working well and looking good, follow these guidelines:
Avoid putting it near heating appliances and devices that generate electrical noise (for example, motors or fluorescent
lamps).
DO NOT expose it to direct sunlight or moisture.
Avoid dropping the product or treating it roughly.
Clean with a soft cloth.
DO NOT immerse the parent unit and the baby unit in water and do not clean them under the tap.
DO NOT use cleaning spray or liquid cleaners.
Make sure the baby unit and parent unit are dry before you connect them to the mains again.
Storage
When you are not going to use the baby monitor for some time, store the parent unit, the baby unit and the adapters in a cool
and dry place.
Frequently asked questions
Below are the questions most frequently asked about the baby monitor. If you cannot find the answer to your question, visit our
website at www.vtechphones.com, or contact 1 (800) 595-9511 for customer service.
To Next Page
Loading...
