EasyManuals Logo

Wacker Neuson BS 50-4 User Manual

Wacker Neuson BS 50-4
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
BS 50-4 Operation
wc_tx000308gb.fm 27
5.7 Proper Operation
See Graphic: wc_gr002612, wc_gr001455
Keep vibratory rammer clean and dry. Avoid no-load strokes. Never
allow the rammer to run full throttle when forcing away material or
when lifting the equipment.
For optimal control, performance, and minimal hand/arm vibration,
grasp handle as shown. Hand/arm vibration (HAV) has been optimized
for this positioning. Reported HAV levels are measured at position A
just in front of the hand position shown in conformance with EN1033
and ISO 5349.
CAUTION: To prevent damage to the rammer, do not allow the
rammer to run on its side.
If the rammer should tip on its side, place the rammer in the position
shown, then shut off the engine by turning engine switch to "OFF".

Other manuals for Wacker Neuson BS 50-4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Wacker Neuson BS 50-4 and is the answer not in the manual?

Wacker Neuson BS 50-4 Specifications

General IconGeneral
Engine ManufacturerHonda
Stroke Height65 mm
Fuel TypeGasoline
Centrifugal Force15 kN
Sound Pressure Level92 dB(A)
Sound Power Level105 dB(A)
Height965 mm
Ramming Shoe Size280 mm
Tank Capacity3.1 l
Fuel Tank Capacity3.1 l
Engine Type4-cycle, single-cylinder, air-cooled
Percussion Rate680 blows/min

Related product manuals