EasyManuals Logo

Wacker Neuson BTS 930 User Manual

Wacker Neuson BTS 930
62 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
T00823GB
16
- When cutting slabs to size, you need not cut through
the entire material thickness (creating unnecessary
dust). Instead, simply make a shallow groove, and
then knock off the excess material cleanly on a flat
surface (25).
CAREFUL!
When cutting into lengths, cutting through material,
making cutouts, etc., always make sure to plan the
direction and sequence of cuts in such a way that the
disc does not get jammed by the cut-off piece, and that
no persons can be injured by falling pieces.
Transport and storage
- Always turn off the Power Cut when transporting it
or moving it from place to place on a site (26).
- Never carry or move the unit with the engine on or
the disc moving!
- Carry the unit only by the tubular (middle) handle with
the cutting disc pointing behind you (26). Avoid
touching the exhaust muffler (burn hazard!).
- When moving the Power Cut over longer distances,
use a wheelbarrow or wagon.
- When transporting the Power Cut in a vehicle, make
sure it is securely positioned in such a way that no fuel
can leak out. Always remove the cutting disc before
transporting the unit in a vehicle.
- The Power Cut should be stored safely in a dry place.
It must not be left outdoors! Always dismount the
cutting disc before storage. Keep the Power Cut away
from children.
- Before long-term storage and before shipping the
Power Cut, follow the instructions in the chapter
on “Periodic care and maintenance“. ALWAYS
empty the fuel tank and run the carburetor dry.
- When putting cutting discs in storage, be careful to:
- Clean and dry them well.
- Store them lying down flat.
- Avoid dampness, freezing temperatures, direct
sunshine, high temperatures and temperature
fluctuations, as these can cause breakage and
splintering.
- Always check new cutting discs or cutting discs
that have been in storage to make sure that they
are free of defects.
Maintenance
- Before performing maintenance work switch off
the Power Cut (27) and pull out the plug cap.
- Always check the Power Cut before using it to make
sure that it is in good working order. In particular, make
sure that the cutting disc is properly mounted. Make
sure that the cutting wheel is undamaged and suitable
for the job it will be used for.
- Operate the Power Cut only at a low noise and
emission level. For this ensure the carburetor is
25
26
27

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Wacker Neuson BTS 930 and is the answer not in the manual?

Wacker Neuson BTS 930 Specifications

General IconGeneral
BrandWacker Neuson
ModelBTS 930
CategoryCutter
LanguageEnglish

Related product manuals