9 Maintenance
100_0202_mt_0012.fm 24
9.1 Maintenance table
9.2 Maintenance jobs
Perform preparations
1. Place the machine on level surface.
2. Shut down the machine.
3. Allow engine to cool down.
Maintenance jobs Daily h/year Weekly Monthly
Clean the machine
Visual inspection for completeness
Visual inspection for damage
Check the engine oil level*
Check the intake area of the combustion air*
Check the to ensure the screwed connections are firmly
seated
Replace the engine oil* 25 h/250 h
Replace the engine oil filter* 25 h/250 h
Check the tapped clearance** 25 h/250 h
Check the rubber buffer** 125 hours
Replace the exciter oil 250 h/1/2
year
Replace the fuel filter* 500 hours
Clean the air cleaner cartridge* 500 hours
Clean, set, repair, replace the injection nozzles* 1500 hours
Clean, set, repair the injection valve* 3000 hours
Check water trap*
Check the exciter oil level
Retention/replace the V-belt
*
Note the engine operator's manual.
**
Have this work performed by the service department of the Wacker Neuson contact partner.
CAUTION
Health risk from fuel, lubricants and coolants.
Do not inhale fuel, lubricants, coolants or vapors.
Avoid contact of skin or eyes with fuel, lubricants and coolants.
WARNING
Risk of fire and explosion from fuel and fuel vapors.
Do not smoke.
Do not refuel near open flames.
Switch off the engine and allow to cool before refueling. Only refuel in a well-ventilated
vicinity.
To Next Page
Loading...
