EasyManuals Logo

Wacker Neuson DPU 4045H User Manual

Wacker Neuson DPU 4045H
38 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
Operation
T00988GB.fm 22
6.6 Additional notes on starting at very low temperatures!
Never use starting sprays or similar - they are forbidden because they
are dangerous.
Only use original Wacker crank.
If cranking, is too slow, the engine can start running in the opposite
direction of rotation.
In this case the air is drawn in through the exhaust and the exhaust
gases excape through the air filter. Risk of fire! Switch off engine and
start it again.
Free the engine by turning it approximately 10 to 20 times with the
decompression lever in a central position. Then the engine is
decompressed, but not ready to start. This intermediate position is
used to turn the engine "free" when at very low temperatures. The
turning resistance becomes appreciably lower owing to the change in
viscosity of the oil film. At the same time you will hear that the nozzle
of the fuel injection system is injecting cleanly (rattling).
At very low temperatures (below -5
o
C), use the starting oil dosing
device.
Note: Do not use more than 2 doses as otherwise there is a risk
of crank back-swing.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Wacker Neuson DPU 4045H and is the answer not in the manual?

Wacker Neuson DPU 4045H Specifications

General IconGeneral
BrandWacker Neuson
ModelDPU 4045H
CategoryPower Tool
LanguageEnglish

Related product manuals