9 Maintenance
100_0202_mt_0008.fm 47
9.2 Maintenance work
Carry out preparations
1. Place the machine on a level surface.
2. Turn the machine off.
3. Let the engine cool.
Make sure the screwed connections are firmly in
place.
Regrease threaded spindle and stop bolt pin
Check starter battery fluid level* 250 h
*Observe engine operator's manual
** This work is to be performed by the Wacker Neuson contact partner's service.
CAUTION
Health hazard due to fuel, lubricants and coolants.
Do not breathe in vapors, fuel, lubricants or coolants.
Avoid skin and eye contact with fuel, lubricants and coolants.
WARNING
Fire and explosion hazard due to fuel and fuel vapors.
No smoking.
Do not refuel near an open flame.
Before fuelling, switch off engine and allow to cool. Refuel only in well-venti-
lated areas.
Maintenance work daily h /Y weekly monthly
To Next Page
Loading...
