Wacker Neuson DPU - 9 Operation and Use; Before Commissioning; Notes about Operation

9 Operation and use
24 100_0202_op_0009.fm
9 Operation and use
9.1 Before commissioning
9.1.1 Inspection before commissioning
 Check the machine and components for damage. In the event of visible damage, do not operate the
machine and immediately contact a Wacker Neuson dealer.
 Ensure that loose packaging material has been removed from the machine.
 Check fuel level.
 Check the engine oil level.
 Check hydraulic oil level.
 Check the fuel lines for leak tightness.
 Check to ensure the screwed connections are firmly seated.
9.1.2 Set center pole
The optimal working height of the center pole can be set by adjusting the threaded spindle.
9.2 Notes about operation
Operation on sloped surfaces
WARNING
Improper handling may result in injury or serious material damage.
 Please read and follow all safety instructions in this operator's manual.
NOTE
Perform control procedures according to the Maintenance chapter. If necessary, top off
missing fuel, lubricants and coolants, see chapterTechnical Data.
Item Designation Item Designation
1 Center pole 2 Threaded spindle
WARNING
Danger of tipping
There is a serious risk of injury from slipping or tipping over of the machine.
Near edges, at least 2/3 of the machine must be on a load-bearing surface.
 Turn off the machine and lift it back onto a load-bearing surface.
WARNING
Health hazard from exhaust fumes
 The exhaust fumes of this engine contain chemicals, which the state of California
knows can cause cancer, birth defects or other reproductive damage.
2
1