9 Operation and use
100_0202_op_0009.fm 29
9.3.5 Machine with Compatec – compaction display (optional)
1. During the first few seconds after commissioning the machine, a light progress bar appears on the
display unit.
2. LEDs light up starting from left to right.
3. All LEDs will briefly light up again at reduced brightness.
4. The sensor is thus successfully tested and the display unit is ready for operation.
9.4 Operation
In accordance with the intended purpose, the operator should stand behind the machine.
Guide and steer machine using the control handle.
9.4.1 Choose travel direction
1. Put throttle control in the full throttle position.
2. Select travel direction and speed with the control handle.
Item Designation Item Designation
1 Display unit 2 LEDs/light progress bar
NOTE
If all LEDs light up, the system is fault-free. The LEDs will then switch off one after the
other.
NOTE
If all LEDs permanently light after initialization, the sensor has not been successfully
tested; see troubleshooting chapter.
Item Designation Item Designation
1 Forward 2 Reverse
To Next Page
Loading...
