BA DT10 en - Edition 1.5 * dt10b320.fm 3-7
Operation
Check lists
The checklists below are intended to assist you in checking and monitoring the machine
before, during and after operation.
These checklists are not intended to be exhaustive; they are only intended to help you to
fulfill your obligation to exercise due care.
The checking and monitoring work listed below is described in greater detail in the follow-
ing chapters.
If the answer to one of the following questions is NO, first rectify the cause of the fault
before starting or continuing work.
"Starting" check list
Check the following points before putting the machine into operation or starting the engine:
Operation checklist
After starting the engine and during operation, check and observe the following points:
"Parking the vehicle" checklist
Check and observe the following points when parking the vehicle:
No.
Question
✔
1
Enough fuel in the tank? (➠ 5-7)
2
Engine oil level OK? (➠ 5-12)
3
Hydraulic oil level OK? (➠ 5-18)
4
Starter cable pull OK?
5
Lubrication points greased? (➠ 5-39)
6
Tracks checked for cracks, cuts, etc.? (➠ 5-28)
7
Especially after cleaning, maintenance or repair work:
➥Rags, tools and other loose objects removed?
No. Question
✔
1
Anyone in the danger zone of the machine?
2
Drive levers working correctly? (➠ 3-13)
No. Question
✔
1
Loader unit (option) lowered to the ground? (➠ 3-17)
When parking on public roads:
2
Machine appropriately secured?
When parking on slopes:
3
Machine also secured with chocks under the tracks to prevent it from rolling
away?
To Next Page
Loading...
Need help?
General
