wc_tx003611gb_FM10.fm
112
Working with Deep Sea Controller: DSE 7310
10.3 Adjusting Screen Contrast
Overview
The contrast of the LCD display can be adjusted to suit the operator’s preference.
Procedure
Perform the procedure below to adjust the screen contrast.
1. Access the “Editor—Display” menu on the LCD panel (f) by pressing and
holding the check mark button (5) on the keypad.
2. Wait a few seconds for the “Contrast” screen to appear, or use up/down arrow
keys to navigate to the “Contrast” screen. Then, press the check mark button.
The contrast value will start flashing.
3. Press the up/down arrow buttons to change the contrast percentage as desired.
When the screen contrast reaches a comfortable viewing level, press the check
mark button to accept the choice.
4. Exit by pressing and holding the check mark button until the genset controller
returns to the “Status” screen.
Result
The screen contrast has now been changed.
DSE
DEEP SEA ELECTRONICS
Alarm
Warning
Main Breaker Open
Low Speed Active
wc_gr009802
5
f
DSE 7310
DEEP SEA ELECTRONICSDEEP SEA ELECTRONICS
DSEDSE
AlarmAlarm
WarningWarning
Main Breaker OpenMain Breaker Open
Low Speed ActiveLow Speed Active
Editor — Disp layEditor — Display
ContrastContrast
55 %55 %55 %55 %
DSE 7310DSE 7310
wc_gr009850
2
3
To Next Page
Loading...
Need help?
General
