wc_tx003229gb_FM10.fm
67
Mobile Generator Working with Basler Controller
8 Working with Basler Controller
8.1 How to Use the Genset Controller LCD and Keypad
Basics
The LCD (a) is used to display information regarding machine performance and
operating status. The keypad (b) is used to maneuver through the various menus
of the genset controller. The keypad is also used to enter and change values of
machine settings.
Actions of the
buttons
To scroll through the options within a menu, use the up/down arrow buttons (2, 3).
When an option on a menu is highlighted, it can be accessed for further submenus.
To do so, press the right arrow button (1).
To return to a previous screen, press the left arrow button (4).
To exit menu navigation and return to monitoring status (or the READY screen),
press and hold the left arrow button.
To access a setting in order to change it, press the check mark button (5).
To cancel an operation, press the “X” reset button (6).
Normal
screens
The machine must be running, or the start switch set to REMOTE START position,
for the genset to be on and active. Sample screens of normal operation are shown
below.
wc_gr010144
Genset monitoring status READY screen
This screen is displayed
when the machine is running.
This screen is displayed when the
start switch is in REMOTE START.
To Next Page
Loading...
Need help?
General
