Wacker Neuson G 25 User Manual

wc_tx003579gb_FM10.fm
60
Mobile Generator
Operation (Basler Controller)
Using the
rheostat
The voltage adjustment rheostat (c) is used to fine-tune the voltage as needed
while the machine is running.
Care must be taken when using the voltage adjustment rheostat because adjusting
the voltage for 3-phase operation affects the voltage available at the single-phase
outlets. As the 3-phase voltage increases, so does the single-phase voltage.
NOTICE: Do not use the GFCI or twist-lock receptacle (120V) when the 1Ø voltage
is above 135V. Damage to the receptacle and the tools connected to it may occur.
1
Do not use receptacle with this voltage.
2
Voltage may be too high for some tools and equipment. Check tool/equipment specifications.
3
Not available on all models.
Switch Position
3Ø Voltage
(L-L-L)
Corresponding 1Ø voltage
Twist lock receptacle
L-L (240V) L-N (120V) 120V GFCI
208 VAC 3Ø
120 VAC 1Ø
208 208 120 120
220 220 125 125
240 240
139
1
139
1
277/480 VAC 3Ø 480 240 139
1
139
1
460 230 133
2
133
2
346/600 VAC 3Ø
3
600
540
AUSAUS
APAGADOAPAGADO
ARRETARRET
OFFOFF
REMOTE STARTREMOTE START
FERNSTARTFERNSTART
ARRANQUE REMOTOARRANQUE REMOTO
DEMARRAGE A DEMARRAGE A
DISTANCEDISTANCE
START / LAUFENSTART / LAUFEN
ARRANQUE / MARCHAARRANQUE / MARCHA
DEMARRER / MARCHEDEMARRER / MARCHE
START / RUNSTART / RUN
E
M
E
R
G
E
N
C
Y
S
T
O
P
A
Ø
HZ
V
R
Basler
DIAGNOSTICS
DIAGNOSEN
DIAGNOSTICOS
DIAGNOSTICS
042563
wc_gr011502
c
A
Ø
HZ
V
R
Basler
DIAGNOSTICS
DIAGNOSEN
DIAGNOSTICOS
DIAGNOSTICS
AUSAUS
APAGADOAPAGADO
ARRETARRET
OFFOFF
REMOTE STARTREMOTE START
FERNSTARTFERNSTART
ARRANQUE REMOTOARRANQUE REMOTO
DEMARRAGE A DEMARRAGE A
DISTANCEDISTANCE
START / LAUFENSTART / LAUFEN
ARRANQUE / MARCHAARRANQUE / MARCHA
DEMARRER / MARCHEDEMARRER / MARCHE
START / RUNSTART / RUN

Wacker Neuson G 25 Specifications

General

Brand	Wacker Neuson
Model	G 25
Category	Portable Generator
Language	English