Table of Contents
G 25
wc_bo5200015081_03_FM10TOC.fm
8
7 Operation (Basler Controller) 54
7.1 Main Circuit Breaker ........................................................................... 54
7.2 Engine Start Switch ............................................................................55
7.3 Genset Pre-Alarms and Alarms (Shut-Down Conditions) ................... 56
7.4 Overcurrent Condition .........................................................................57
7.5 Using the Lugs and the Convenience Receptacles ............................58
7.6 Selecting the Voltage ..........................................................................59
7.7 Before Starting the Machine ...............................................................61
7.8 Starting and Running the Machine .....................................................62
7.9 Stopping the Machine .........................................................................64
7.10 Emergency Stop Switch ...................................................................... 64
7.11 LCD Panel: Monitoring Machine Operation ........................................65
8 Working with Basler Controller 67
8.1 How to Use the Genset Controller LCD and Keypad ..........................67
8.2 Menu Diagram of the Genset Controller .............................................68
8.3 Menu Diagram Components ............................................................... 69
8.4 Using the Metering and Settings Menus .............................................70
8.5 Logging in to the Genset Controller by Entering the Password .......... 71
8.6 Adjusting the LCD Screen Contrast ....................................................74
8.7 Changing the Time/Date Settings .......................................................75
8.8 Changing the Sender Fail Time Delays ..............................................76
8.9 Changing the Units of Measure ..........................................................78
8.10 Changing the Low Fuel Pre-Alarm Setting .........................................80
8.11 Changing or Disabling the Low Fuel Alarm Setting ............................82
8.12 Changing the Cooldown Time Setting ................................................ 84
8.13 Changing the Pre-Crank Time Delay (Glow Plug Timer) ....................86
8.14 Changing the Maintenance Interval ....................................................88
8.15 Resetting the Maintenance Interval Pre-Alarm ................................... 90
8.16 Resetting a Loss of Voltage Pre-Alarm ............................................... 92
8.17 Accessing and Using the Event Log ................................................... 93
9 Operation (Deep Sea Controller) 95
9.1 Main Circuit Breaker ........................................................................... 95
9.2 Genset Controller Power Switch .........................................................96
9.3 Selecting the Voltage ..........................................................................97
9.4 Deep Sea Controller Buttons/Functions .............................................99
9.5 Genset Controller Alarms and Shut-Down Conditions ...................... 101
To Next Page
Loading...
Need help?
General
