Mobile Generator Using the LCD Panel and Keypad
wc_tx001182gb.fm 59
5.4 Setting the Time or Date
See graphic: wc_gr005938
The control module features a clock powered by a separate battery.
Follow the steps below to change the time or date.
5.4.1 To access the main menu, press the right arrow button (1) on the
keypad (g).
Note: If there are active alarms or pre-alarms, press the left arrow (4)
three times to access the main menu.
5.4.2 Using the up/down arrow buttons (2,3), select SETTINGS, and press
the right arrow button.
5.4.3 Select GENERAL SETTINGS. Press the right arrow button.
5.4.4 Select CONFIGURE DATE/TIME. Press the right arrow button.
5.4.5 Select the item to change. Press the check mark button (5).
5.4.6 If necessary, enter your password. (See Entering Passwords for more
information.)
5.4.7 Use the up/down arrow buttons to change the value as desired. Press
the check mark button when finished.
5.4.8 Exit by repeatedly pressing the left arrow until the LCD panel display
returns to monitoring status.
To Next Page
Loading...
