GH 3500 Safety information
Operator's manual 11
Loading
Loading ramps must be able to bear the load and be in a stable position.
Make sure that no one can be endangered if the machine slips away or tips over
or if parts suddenly move upward or downward.
Put the operating controls and moving parts in their transport position.
Secure the machine with load-securing straps so that it cannot roll or slide away
or tip over. Only use the attachment points described in the operator's manual.
Transport vehicle
Use only suitable transport vehicles with sufficient load-carrying capacities.
Restarting
Parts, accessories or tools that have been detached for transport purposes must
be carefully re-mounted and fastened before you restart the machine.
When you restart the machine, only proceed as described in the operator's man-
ual.
3.4 Operation
Minimum distance
Stationary power units and drives must have a distance of at least one meter
from equipment, buildings or other machines.
Do not use in the rain
Protect the machine against rain, snow or any other forms of moisture.
This could cause damage or malfunctions.
Protection against water
Only operate the machine on a dry surface.
If water accumulates under the machine, you must switch off the machine and
let it dry properly.
Protection against overload
Always make sure that the power unit is not overloaded. The total amperage of
the components connected may not exceed the output limit for the power unit.
To Next Page
Loading...
Need help?
General
