ghi_tx001462gb_FM10.fm
42
Operation HI400HD D / HD G
4.16 Setting the Gas Selector Valve (G models)
Overview
Your machine is configured at the factory to operate on natural gas. The gas
selector valve on the gas train allows you to convert the machine from natural gas
to LP as job site conditions require.
Procedure
Perform the procedure below to change the type of gas.
1. Ensure that the gas shutoff valve is closed.
2. Loosen the screw (a) on the gas selector valve.
3. Turn the handle to the desired position.
4. Tighten the screw.
5. Open the gas shutoff valve.
To Next Page
Loading...
