Wacker Neuson IRFU Series User Manual

11 Malfunctions
100_0101_ts_0001.fm 35
11 Malfunctions
Please refer to the following table if the machine does not work properly. It con-
tains potential faults, their causes and remedies.
11.1 Bodyguard
®
11.2 Inverter
Malfunction Cause Remedy
Control lamp lights red.
The line voltage is applied.
 The Bodyguard
®
has turned
off the machine.
 Machine malfunction.
1. Pull the plug from the plug re-
ceptacle.
2. Check power cable for dam-
age – if damaged, have it re-
placed. *
3. Insert the plug into the plug
receptacle.
If the fault is not remedied, have
the machine repaired. *
* Have these tasks carried out by the service department of your Wacker Neuson representative per-
son.
 Water in inverter.
 Defect in the vibrator head.
Have the machine repaired. *
Control lamp does not light up. No line voltage. 1. Pull the plug from the plug re-
ceptacle.
2. Check power cable for dam-
age – if damaged, have it re-
placed. *
3. Insert the plug into the plug
receptacle.
Bodyguard
®
is defective. Have the machine repaired. *
Malfunction Cause Remedy
Control lamp lights red.
 Line voltage is interrupted.
 Incorrect line voltage.
Inverter starts automatically as
soon as the correct line voltage
is available (again).
Control lamp flashes red. Defect in the vibrator head. Have the machine repaired. *

Wacker Neuson IRFU Series Specifications

General

Brand	Wacker Neuson
Model	IRFU Series
Category	Construction Equipment
Language	English