Operation PT 3 / PT 3A / PT 3H
28 wc_tx001779gb.fm
4.9 To Start (Hatz)
See Graphic: wc_gr000016
4.9.1 Set speed control lever (a) either to 1/2 START or max. START
position, as desired or necessary.
Note: Starting at a lower speed will help to prevent exhaust smoke.
4.9.2 Pull the starting cable out by hand until you feel a slight resistance (b).
4.9.3 Let the cable run back; in this way the entire length of the starting cable
can be used to start the engine.
4.9.4 Grip the handle with both hands.
4.9.5 Commence pulling the starting cable vigorously and at an increasing
speed (do not jerk it violently) until the engine starts.
Note: If after several attempts of starting, the exhaust begins to emit
white smoke, move the speed control lever to the STOP position and
pull the starting cable out slowly 5 times. Repeat the starting
procedure.
To Next Page
Loading...
Need help?
General
