Putting into operation 4
BA TH412 * 06/2017 * 4512_4-4_Vorbereitung_en.fm
4-39
Requirements and information for the operating personnel
• The machine may only be put into operation by autho-
rized personnel that have been instructed.
• The operating personnel must have read and under-
stood this Operator’s Manual before putting the
machine into operation.
• Use the steps and handholds when entering and
leaving the cabin.
• Face the machine as you enter and leave it
• Never use the controls or movable lines and cables as
handholds.
• Keep the footholds and the handholds clean to ensure
a safe hold at all times. Immediately remove dirt, such
as oil, grease, earth, snow or ice.
• The machine may only be put into operation when the
operator is seated.
• Fasten the seat belt (lap belt).
• Never get on a moving machine. Never jump off the
machine.
• Before leaving the machine, lower the loader unit, stop
the diesel engine and apply the parking brake.
• Carrying or transporting accompanying persons in the
cabin and/or on the machine is prohibited.
• The machine may only be used in technically perfect
condition in accordance with its designated use and
the instructions set forth in the Operator’s Manual, and
only by safety-conscious persons who are fully aware
of the risks involved in operating the machine.
• Always observe the warning and information labels,
and the load diagrams (for example pallet forks) of the
loader unit.
• Immediately replace (or have replaced) damaged or
illegible warning and information labels with new ones.
To Next Page
Loading...
Need help?
General
