Putting into operation 4
BA TH412 * 06/2017 * 4512_4-5_Motor_starten_en.fm
4-51
Stopping the engine
1. Lower the loader unit fully to the ground.
2. Apply the parking brake.
3. Let the engine run at idling speed for about 3 minutes
4. Stop the engine.
➥ Turn the starting key to position 0.
5. Remove the starting key.
Stopping the engine after running it under full load can
cause damage.
► Let the engine run at idling speed for about 3 minutes
so that the temperature can stabilize before stopping
the engine.
Immediately starting the engine after stopping it can
damage the starter.
► Wait at least 10 seconds before starting again.
To Next Page
Loading...
Need help?
General
