Transportation 6
BA TH412 * 06/2017 * 4512_6-2_Verladen_en.fm
6-7
Loading the vehicle
Load as follows:
Preparations
1. Secure the transport vehicle with wheel chocks to
prevent it from rolling away.
2. Place the access ramps at the smallest possible angle.
➥ Do not exceed an angle of 25°.
➥ Use access ramps only with an antiskid surface.
3. Ensure that the loading area is clear and access to it is
not obstructed, by superstructures for example.
4. Ensure that the access ramps and the wheels of the
machine are free of snow, ice, oil or grease.
5. Check the engine oil level of the machine to be loaded.
➥ The oil level must be visible at the MAX mark of the
oil dipstick.
Loading
1. Start the vehicle.
2. Raise the loader unit enough so that it will not touch
the access ramps.
3. Ensure that the attachment is securely locked.
4. Carefully drive the vehicle onto the middle of the
transport vehicle.
5. Switch the drive to the zero position.
6. Apply the parking brake.
7. Lower the loader unit to the loading area.
8. Stop the engine.
9. Remove the starting key.
10.Leave the cabin, close and lock the doors and engine
cover.
11.Ensure that the permissible maximum height of the
transport vehicle is not exceeded.
To Next Page
Loading...
Need help?
General
