Safety 2
BA TH412 * 06/2017 * 4512_2-1_Sicherheit_en.fm
2-11
Lifting gear applications
• The machine and the attachment must be certified for
lifting gear applications.
• Observe the national regulations for lifting gear appli-
cations.
• Lifting gear applications are procedures involving
raising, transporting and lowering loads with the help
of lifting and fastening gear.
• The help of an accompanying person is necessary for
fastening, guiding and removing the load.
• There must be nobody under the load.
• Stop the vehicle immediately and stop the engine if
persons enter the danger zone.
• Use the machine for lifting gear applications ONLY if
the mandatory lifting gear (for example, a joint rod and
load hook) and safety equipment (for example, optical
and acoustic warning devices, hose burst valve,
stability table) is installed and functional.
• Use only lifting and fastening gear certified by a test/
certification body, observe the inspection intervals
(Use only chains and shackles. No belts, slings or
cables).
• Do not use any lifting and fastening gear that is dirty,
damaged or not of sufficient size.
• Do not interrupt the work process with a load attached.
To Next Page
Loading...
