Safety
Maintenance 4.11
21
[en] | 02/2020 | 5100056064 | VP | Operator’s manual
4.11.2 Vehicle fluids
• Always wear protective goggles and gloves when handling vehicle
fluids. Seek medical advice immediately if, for example, hydraulic oil,
fuel, oil or coolant gets into the eyes.
• Avoid direct skin contact with vehicle fluids. Wash skin immediately
with soap and water.
• Do not eat or drink while working with vehicle fluids.
• Contaminated vehicle fluid (e.g. with dirt, water) can lead to prema-
ture wear or failure of the machine.
• Dispose of discharged or spilled vehicle fuel in accordance with ap-
plicable environmental regulations.
• If vehicle fluids leak from the machine, stop operating the machine
and have it repaired immediately by a Wacker Neuson contact.
4.11.3 Combustion engine
• Before starting work, check the engine for leaks and cracks in the fuel
line, tank and filler cap.
• Do not start the defective motor. Replace damaged parts immedi-
ately.
• The preset engine speed must not be adjusted. This could lead to en-
gine damage.
• Ensure that the exhaust system of the engine is free of waste. Fire
hazard!
• Before refueling, switch off the engine and let it cool down.
• Use the correct type of fuel. Observe the prescribed mixing ratios.
• Use clean filling aids for refueling. Do not spill fuel, wipe up spilled
fuel immediately.
• Do not start the engine near spilled fuel. Explosion hazard!
• When operating in partially enclosed rooms, sufficient ventilation
must be provided. Do not inhale exhaust gas. Danger of poisoning!
• The engine surface and exhaust system can become very hot after
only a short time. Risk of burns!
• Do not use jump start sprays. These can cause misfiring and engine
damage. Fire hazard!
4
To Next Page
Loading...
Need help?
General
