Safety
4.11 Maintenance
20
Operator’s manual | VP | 5100056064 | 02/2020 | [en]
4.11 Maintenance
• This machine must not be serviced, repaired, adjusted or cleaned
when switched on.
• Observe maintenance intervals.
• Observe maintenance plan. Any work not listed must be carried out
by the Wacker Neuson representative.
• After any maintenance or repair, the safety devices must be reat-
tached to this machine.
• Always replace worn or damaged machine parts immediately. Use
only spare parts from Wacker Neuson.
• Keep the machine clean.
• Replace any missing, damaged or illegible safety labels immediately.
Safety labels contain important information to protect the operator.
• Maintenance work must be carried out in a clean and dry environ-
ment (e.g. workshop).
4.11.1 Service
• Only have the machine repaired or serviced by technically trained
personnel.
• Only use original spare parts and accessories. This ensures the oper-
ational safety of the machine.
Threaded fittings
All threaded fittings must comply with the specified specifications and be
firmly bolted together. Observe the tightening torques! Screws and nuts
must not be damaged, bent or deformed.
Particular attention should be paid to the following:
• Self-locking nuts and micro-encapsulated screws must not be reused
after loosening. The fastening effect is lost.
• Threaded fittings with adhesive protection/liquid adhesives (e.g. Loc-
tite) must be cleaned after loosening and provided with new adhes-
ive.
Information
Observe the instructions of the liquid adhesive manufacturer.
To Next Page
Loading...
Need help?
General
