Malfunctions
Troubleshooting 10.1
39
[en] | 02/2020 | 5100056064 | VP | Operator’s manual
10 Malfunctions
10.1 Troubleshooting
WARNING
Danger to life due to unauthorized troubleshooting!
► If faults occur on this machine which are not described in these in-
structions, contact the manufacturer.
► Do not rectify faults on your own.
Fault Possible cause Remedy
The engine cannot be started. Engine switch off. Engine switch on.
Throttle lever in stop or idle position. Throttle lever on.
Not enough fuel. Refill with fuel. Check fuel filter and
fuel lines.
Incorrect valve clearance. Check valve clearance, have it ad-
justed if necessary.*
Valves worn. Have the machine repaired.*
Cylinder and/or piston ring worn.
Spark plugs worn.
Engine oil level too low. Add engine oil.
No vibration when the engine is run-
ning.
V-belt worn. Change V-belt.
Clutch linings worn out. Have the clutch linings replaced.*
* Have this work carried out by a service partner.
10
To Next Page
Loading...
Need help?
General
