17
Control Pro 250 R / 350 R
GB
Congratulations on your purchase of a WAGNER colour application device.
You have purchased a proprietary device that requires careful cleaning and care to ensure trouble-free functioning. Read the
operating instructions carefully before using the tool and observe the safety instructions. Keep the operating instructions
in a safe place.
Explanation of symbols used
Danger
Indicates an immediate danger. Unless avoided, death or serious injuries will result.
i
Indicates tips for use and other particularly useful information.
Wear suitable ear protection when working.
Wear suitable respiratory equipment when working.
Wear suitable safety gloves when working.
General Safety Instructions
Warning!
Read all safety notications and instructions. Failure to comply with the safety notications and instructions provided
may result in electric shock, re and/or serious injury. Save all warnings and instructions for future reference. The term
"power tool" used below covers both mains-operated power tools (with mains lead) and accumulator-operated power
tools (without mains lead).
Danger
1. Safety at the workplace
a) Keep your workplace clean and well lit. Disorder or unlit workplaces may result in accidents.
b) Never use the tool in hazardous areas that contain ammable liquids, gases or dusts. Power tools generate sparks that
can ignite the dust or vapors.
c) Keep children and other persons away when using the power tool. You can lose control of the tool if you are distracted.
2. Electrical Safety
a) The tool plug must t into the socket. The plug may not be modied in any form. Do not use adaptor plugs together
with protective-earthed tools. Unmodied plugs and suitable sockets reduce the risk of an electric shock.
b) Avoid physical contact with earthed surfaces such as pipes, heating elements, stoves and refrigerators. The risk
through electric shock increases if your body is earthed.
c) Keep the equipment away from rain and moisture. The risk of an electric shock increases if water penetrates electrical
equipment.
d) Do not misuse the mains lead by carrying the tool by the lead, hanging it from the lead or by pulling on the lead
to remove the plug. Keep the lead away from heat, oil, sharp edges or moving tool parts. Damaged or twisted leads
increase the risk of an electric shock.
e) If you work outdoors with a power tool, only use extension cables suitable for outdoor use. The use of an extension lead
that is suitable for outdoors reduces the risk of an electric shock.
f) If you cannot avoid using the tool in a damp environment, use a residual current operated circuit-breaker. Using a
residual current operated circuit-breaker avoids the risk of electric shock.
To Next Page
Loading...
Need help?
General
