EasyManuals Logo

WAGNER CONTROL PRO 250 R User Manual

WAGNER CONTROL PRO 250 R
Go to English
144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
21
Control Pro 250 R / 350 R
GB
Description (Fig. 1)
1 Suction hose 2 Pressure regulator with integrated ON/OFF switch
3 Carry handle 4 Integrated toolbox for nozzles and small parts
5 Nozzle 517 (for thick materials, e.g. interior wall paints) 6 Spray Gun
7 Nozzle holder 8 HEA Filter Set
9 Gun lter: red (1 pc.), white (1 pc.*) 10 Nozzle 311 (for thin materials, e.g.
lacquers)
11 High-pressure hose 12 Selector switch
13 Return hose 14 Hose connection
15 Inlet lter 16 Inlet valve pusher
17 Operating instructions
* pre-installed in the lter housing
Coating Materials Suitable for Use
Dispersion and latex paints for interior use.
Water-based and solvent-containing lacquers and glazes. Paints, oils, release agents, synthetic enamels, PVC lacquers, undercoats,
base coats, llers and anti-rust paints.
i
Another nozzle size and gun lter must be used, depending on the material to be processed.
Thin materials: Nozzle 311
Æ
Filter red
Thick materials: Nozzle 517/619
Æ
Filter white
Coating Materials Not Suitable for Use
Materials that contain highly abrasive components, facade paint, caustic solutions and acidic coating substances.
Flammable materials, materials containing acetone or cellulose thinner
i
In order to ensure compatibility of the coating substance with the materials used to manufacture the device, please
contact Wagner Service in cases of doubt.
Field of application
Coating interior walls and outside objects (e.g. garden fences, garage doors, etc.).
Required tools and auxiliary material
Wrench (13, 16, 17, 20) and/or adjustable wrench (2 pcs.) and hex key (10 mm)
Hex key (2.5 mm)
Empty container
A large piece of cardboard
Covering material
Preparation of the workplace
Danger
Sockets and plugs must be masked. Risk of an electric shock as a consequence of sprayed material entering the
socket!
Mask all the areas and objects that are not to be spray painted, or remove them from the work area.
No liability is assumed for damage due to overspray.
Silicate paint corrodes glass and ceramic surfaces upon contact! All such surfaces must therefore be completely
covered.
i
Pay attention to the quality of the adhesive tape used. Do not use excessively strong adhesive tape on wallpaper and
painted surfaces, in order to avoid damaging these surfaces when removing the tape. Remove adhesive tape slowly
and evenly; do not use jerky movements. Do not leave adhesive tape on surfaces any longer than necessary, in order to
minimise the possibility of residues when removing. Also observe the adhesive tape manufacturer's instructions.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the WAGNER CONTROL PRO 250 R and is the answer not in the manual?

WAGNER CONTROL PRO 250 R Specifications

General IconGeneral
BrandWAGNER
ModelCONTROL PRO 250 R
CategoryPaint Sprayer
LanguageEnglish

Related product manuals