Operating manual Piston Pump EvoMotion 20-30
6 Assembly and Commissioning
Order number 2333553 | Edition 09/2020 27
6 ASSEMBLY AND COMMISSIONING
6.1 TRAINING OF ASSEMBLY/COMMISSIONING PERSONNEL
– The assembly and commissioning personnel must have the technical skills to safely
commission the device.
– When assembling, commissioning and carrying out all work, read and follow the
operating manuals and safety regulations for the additionally required system
components.
A skilled person must check to ensure that the device is in a reliable state after it is
assembled and commissioned.
6.2 STORAGE CONDITIONS
Until the point of assembly, the device must be stored in a dry location, free from vibrations
and with a minimum of dust. The device must be stored in closed rooms.
Die Lufttemperatur am Lagerort muss in einem Temperaturbereich zwischen -20°C und
+60°C; -4°F und +140°F liegen.
The relative air humidity at the storage location must be between 10 and 95% (without
condensation).
6.3 INSTALLATION CONDITIONS
The air temperature at the installation site must be in a range between 4°C and 40°C; 39°F
and 104°F.
The relative air humidity at the installation site must be between 10 and 95% (without
condensation).
6.4 TRANSPORTATION
The pump can be moved on a trolley or manually without lifting equipment or a crane.
6.5 ASSEMBLY AND INSTALLATION
WARNING
Inclined ground!
Risk of accidents if the device rolls away/falls.
4 Place device on level ground and secure it.
4 If the floor is inclined, position the feet of the trolley towards the gradient.
4 Secure the trolley.
Info
Ensure that the national explosion prevention rules and regulations are observed when
setting up the device.
This pump can be used as part of a spraying system for Airless or AirCoat applications.
Individual supplement components for this pump can be found in the Wagner accessories
catalogue, or can be put together with a spraypack configurator. The nozzles must be
selected according to the spray gun operating manual. In the case of spraypack orders, the
pumps (1) are already pre-mounted on a trolley (6) or on a frame at the factory.
To Next Page
Loading...
