Operating manual Piston Pump EvoMotion 20-30
10 Repairs
Order number 2333553 | Edition 09/2020 47
10.3 TOOLS
The following tools are required for assembling and disassembling the device (if possible,
always bring entire tool sets with you):
– Torque wrench 4.5 Nm; 3.3 lbft / 20; 14.7 / 30; 22.1 / 35; 25.8
– Circlip pliers 30mm (inside)
– Set of slot-head screwdrivers
– Set of Phillips screwdrivers
– Set of Allen wrenches
– Set of wrenches
10.4 CLEANING THE PARTS AFTER DISASSEMBLY
WARNING
Incompatibility of cleaning agent and working medium!
Risk of explosion and danger of poisoning by toxic gases.
4 Examine the compatibility of the cleaning agents and working media on the basis of
the safety data sheets.
Please note:
1. Thoroughly clean all reusable parts with a suitable cleaning agent.
2. All dismantled parts have to be clean and dry after cleaning. Care should be taken that
these parts remain free of solvents, grease or sweat from the hands (salt water). Perform
cleaning and mounting tasks wearing gloves.
10.5 ASSEMBLY OF THE DEVICE
In Chapter Spare Parts [853] the order numbers for device spare parts can be found, as
well as for wearing parts such as seals.
1. Defective parts, O-rings and seal sets must always be replaced.
2. Use greases and glues in accordance with Chapter Spare Parts [853].
3. Observe torque specifications in Chapter Spare Parts [853].
Assembly aids:
Order no. Quantity Designation Smaller tanks
9992590 1pc ≙ 50ml Loctite® 222
9992511 1pc ≙ 50ml Loctite® 243
9992528 1pc ≙ 50ml Loctite® 270
9992831 1pc ≙ 50ml Loctite® 542
9998808 1 pc ≙ 18 Kg! Mobilux® EP 2 grease 400 g tube ≙ order no. 2355418
9992616 1pc ≙ 1kg can Molykote® DX grease 50 g tube ≙ order no. 2355419
9992609 1 pc ≙ 100 g Anti-seize paste
9992816 1 pc ≙ 70 g Miranit contact adhesive
Brand notice
The brands specified in this document are property of the respective owners. Loctite®, for
example, is a registered brand of Henkel.
To Next Page
Loading...
