40
B_04222
9
10
10
B_04223
11
10
B_04221
8
8Nm
5.9 lbft
OPERATING MANUAL
VERSION 01/2013 ORDER NUMBER DOC 2335747
In the following assembly instructions, apply the right torques, greases and glues according
to Chapter 10.2!
m) Mount one internal diaphragm cover (8) on the motor block, with the appertaining
seals and shaft guide bushing.
n) Insert the spring (9) in the cross hole of the shaft, and grease it at the ends.
o) Put the two halves of the sliding shoe on the shaft, make sure to keep the steps (10)
opposite each other.
p) Insert the shaft with the sliding shoe into the motor block, making sure that the steps
(10) are each aligned in the direction of the drillings (11) in the block (according to the
gure, analog to the backside).
To Next Page
Loading...
