EasyManua.ls Logo

WAGNER PM500 - Safety Parameters; Processible Materials

WAGNER PM500
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
OPERATING MANUAL
VERSION 01/2013 ORDER NUMBER DOC 2335747
2.4 SAFETY PARAMETERS
WAGNER accepts no liability for any damage arising from incorrect use.
Use the device only to work with the materials recommended by WAGNER.
Only operate the device as a whole.
Do not deactivate safety  xtures.
Use only WAGNER original spare parts and accessories.
2.5 PROCESSIBLE MATERIALS
Fluid materials like paints and varnishes.
Abrasive materials and pigments!
Greater wear of parts carrying the material.
Use the application-oriented model ( ow rate/cycle, material, valves, etc.) as
indicated in Chapter 5.3.2.
Check if the  uids and solvents used are compatible with the pump construction
materials as indicated in Chapter 5.3.1.
NOTICE
The operation of the pneumatic double diaphragm pump is only allowable under the
following conditions:
The operating sta have previously been trained on the basis of this operating
manual.
The safety regulations listed in this operating manual must be observed.
The operating, maintenance and repair information in this operating manual must
be observed.
The statutory requirements and accident prevention regulation standards in the
country of use must be observed.

Table of Contents

Related product manuals