WAGNER ProjectPro 213 Extra - Page 22

F
16
ProjectPro 213 ExtraGB
16
ProjectPro 213 Extra
Before working on the spray gun remove the power plug from the socket.
•
Cover areas that are
•
not to be sprayed. When working keep in mind that wind, for example,
may transport paint mist over great distances and cause damage.
The units may only be used with a functional valve.
•
If paints rises in the ventilating
hose (Fig. 12 A, item 14) do not operate the unit further! Dismantle and clean the
ventilating hose, valve and diaphragm and replace the diaphragm if necessary.
Do not lay the spray gun.
•
The device is equipped with a thermal release which disconnects the device in case of
•
overheating. In this case, turn o the device, remove the plug and let the device cool
down for at least 1/2 hour. Eliminate the cause of heating, e.g. bent hose, soiled air lter,
slots for air intake covered.
With original WAGNER accessories and spare parts, you have the guarantee that all
safety regulations are fullled.
Technical Data
Max. viscosity 170 DIN-s
Max. ow rate 240 g/min
Power source 230 - 240 V
~
Power consumption 570 W
Atomizing output: 130 W
Double insulation
Sound pressure level 80 dB (A)
Oscillation level < 2,5 m/s
Air hose length 7,5 m
Weight 13,6 kg
TechnDat_GB
Description (Figs. 1+2)
Air cap 1) Tip2)
Union nut 3) Standard spray attachment4)
Trigger guard 5) Material volume regulation6)
Gun handle 7) Air volume control8)
ON/OFF switch 9) Air hose10)
Frame 11) Frame carry handle12)
Frame cover/ Gun holder 13) Air hose retainer14)
Fastening belts for air hose 15) Basic device cover16)
Basic device closure 17) Main switch18)
Air hose connection 19) Frame base20)
Basic device21) Frame closure22)
Container 23) Valve24)
Ventilating hose 25) Fastener for radiator/detail spray 26)
attachment (accessory
Deposition tray for hardware 27) Cover of air lter compartment28)
Air lter29) Cable grommet30)
Power cable31) Rubber band32)
Deposition tray for spray attachments33)