WAGNER ProjectPro 213 Extra - Preparation of the Coating Material

GB
17
ProjectPro 213 Extra
Jet Air
With Wagner's new "Jet Air" technology, nozzle and air cap have small indentations
which cause air turbulence. This enables the use of aerodynamic advantages similar
to those of a golf ball, which result in an optimised air ow and consequently a better
spray pattern.
Spray attachment
Brilliant spray attachment
(Air cap, blue)

Optimised nozzle and air guidance for brilliant
paint results
Perfect Spray 800 spray
attachment (Air cap, red)

For medium- and large-scale objects and
furniture.
Coating Materials Suitable for Use
Water- and solvent-based paints, nishes, primers, 2-component paints, clear nishes,
automotive nishes, staining sealers and wood sealer-preservatives.
Coating Materials Not Suitable for Use
Wall paints (emulsion paints) etc., alkali and acidic paints. Coating materials with a ash
point below 21°C.
Preparation of the Coating Material
The enclosed spray attachment can be used to spray paints, varnishes and glazes that are
undiluted or slightly diluted. Detailed information is available in the technical data sheet
of the manufacturer ( Internet download).
1. Stir the material up and put the required amount into the paint container.
Thinning recommendation
Sprayed material
Glazes undiluted
Wood preservatives, mordants, oils,
disinfection agents, plant protective agents
undiluted
Paints containing solvents and water-soluble
paints, primers, vehicle coating paints,
thick-lm glazes dilute by 5 - 10%
2. If the convey capacity is too low, add 5 - 10% dilution step-by-step until the convey
capacity fulls your requirements.
Start-up
Before connecting to the mains supply, be sure that the supply voltage is identical with
the value given on the rating plate.
ATTENTION: Do not sit or stand on the device. Danger of tilting/breaking!
Place the device only on a plane and clean surface. Otherwise, the gun may suck in 1.
dust, etc