Malfunction Cause Remedy
No coating material
emerges from the
nozzle
Nozzle clogged
Material volume setting turned too far
to the left (-)
No pressure build-up in container
Container empty
Feed tube loose
Feed tube clogged
Clean
Turn to the right (+)
Tighten container
Rell
Insert
Clean
Atomisation too coarse Material volume too large
Material volume adjusting screw turned
too far to the right (+)
Nozzle contaminated
Viscosity of coating material too high
Too little pressure build-up in container
Air lter heavily soiled
Amount of air too low
Turn material volume adjusting
screw to the left (-)
Clean
Add 5 - 10% dilution
Tighten container
Change
Turn the air volume control to
the right (+)
Spray jet pulsates Coating material in container running
out
Nozzle seal worn
Air lter heavily soiled
Rell
Replace
Change
Coating material causes
"paint tears"
Too much coating material applied. Turn material volume adjusting
screw to the left (-)
Too much fog of
coating material
(Overspray)
Distance to the object too large
Too much coating material applied
Amount of air too high
Reduce distance
Turn material volume adjusting
screw to the left (-)
Turn the air volume control to
the left (-)
Paint in the ventilating
hose
Diaphragm soiled
Diaphragm defective
Clean the diaphragm
Replace the diaphragm
Device does not
function
Device overheated Unplug the power plug, let
the device cool down approx.
30 minutes, do not bend the
hose, check the air lter, do not
cover the intake slots
Warning
If the supply cord of this appliance is damaged, it
must only be replaced by a repair shop appointed by
the manufacturer, because special purpose tools are
required.
Warning: Do not connect the blue or brown wire to the
earth terminal of the plug! The wires in this mains lead
are coloured in accordance with the following code:
blue = neutral brown = live
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifiying the terminals in your plug,
proceed as follows:
To Next Page
Loading...
