12
PXM
P_02627
P_02628
OPERATING AND ASSEMBLY MANUAL
VERSION 08/2015 ORDER NUMBER DOC2350372
3 IDENTIFICATION
3.1 EXPLOSION PROTECTION IDENTIFICATION
The PXM powder center is intended for construction outside of the dust Ex-zone (Zone 22).
3.2 PERMISSIBLE DEVICE COMBINATIONS
The following components may be used in the PXM powder center:
PI-F1 injector
Hi-Coat ED injector
Ultrasonic screening device (version for PXM with replaceable lter)
IP 5000 powder pump
EPG S2 control unit
EPG-Sprint X control unit
MCC controller
MCS 1 controller
CPD 1
3.3 TYPE PLATE
Powder center Control cabinet
Note:
The type plate may only be attached with the CE mark if the complete installation
(powder center, controller, add-on parts, etc.) complies with the provisions of the
EC directives.
To Next Page
Loading...
Need help?
General
