EasyManuals Logo

WAGNER PXM User Manual

WAGNER PXM
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #39 background imageLoading...
Page #39 background image
39
PXM
OPERATING AND ASSEMBLY MANUAL
VERSION 08/2015 ORDER NUMBER DOC2350372
6.9 STANDARD SETTINGS
The most important settings for speedy commissioning of the powder center have already
been carried out by the manufacturer.
You can, however, change standard settings to suit your needs. The changes remain saved
even if the powder center is switched o with the main switch.
The following standard settings are made in the factory.
Workstation
Alarm delay powder shortage: 30 sec.
FP supply
FP station: 1
FP bigbag: 1
Bigbag type: IP 5000
FP redosing time manual: 30 sec.
FP redosing time automatic: 30 sec.
RP supply
RP supply: Yes
Operating mode: Eco
RP feed time: 50 sec.
RP break time: 10 sec.
Message recovery system: 60 sec.
RP supply: Cycle 1: 2.5 sec.
Cycle 2: 0.3 sec.
Cycle 3: 2.5 sec.
Cycle 4: 0.3 sec.
US sieve
US sieve: No
After-run time if US sieve available: 30 sec.
Dirt discharge: 3 pulses
After-run time before: 12 sec.
Wait time: 10 min.
Pulse time: 1.0 sec.
Break time: 5.0 sec.
Exhaust system
Exhaust system: Integrated
Filter cleaning pulse time: 0.2 sec.
Filter cleaning break time: 60 sec.
Final  lter, automatic closing: 10 sec.
6.9.1 MACHINE PARAMETERS OPERATION

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the WAGNER PXM and is the answer not in the manual?

WAGNER PXM Specifications

General IconGeneral
BrandWAGNER
ModelPXM
CategoryIndustrial Equipment
LanguageEnglish

Related product manuals