4
eN
cleanup
1
2
3
4
5
x5
beFore you begiN cleaNiNg
• If you used latex-based materials, use warm, soapy water
to clean the Smart Roller.
• If you used oil-based materials, use mineral spirits.
you will Need
• A large bucket or other container that will hold cleaning
solution.
TIP: A large laundry tub lled with warm, soapy water is ideal
for cleanup if you used latex-based materials.
cleanup (1-8)
1. Pull plunger back to draw remaining material from the
roller arm assembly into the tube.
2. Press the ll valve onto the ll tube. Push plunger
forward to return excess material into the container.
3. Press locking tab and remove roller cover assembly from
the roller arm.
4. Remove the roller cap. Push the roller core out the other
end. Place spatter guard, cap, core and cover in a bucket
of the appropriate cleaning solution.
5. Unclip ll tube from container, but keep installed into
the ll valve. Submerge the ll tube into the appropriate
cleaning solution and pull the plunger in and out a
minimum of 5 times.
To Next Page
Loading...
Need help?
General
